Complete crankshaft and big end assembly pressed and trued, ready for fitting to crankcase. (EXCHANGE ONLY) Advantages The Vee Two lightened, balanced and polished crankshaft is approximately 2kgs (5lbs) lighter than standard. The advantages in performance and reliability are considerable. Lightened flywheels reduce rotating mass. This not only quickens throttle response and acceleration, but also actually lifts horsepower. Engine reliability is improved because the lighter flywheels significantly decrease loadings on crankcases and main bearings. The balance factor remains standard to retai... [view details]

Replacement big end assembly for Squarecase SS with straight (38mm) pin.

Advantages

Pivotal to all reliable power is the VEE TWO BigEnd Assembly, which are so strong, they are guaranteed for 12 months with unlimited kilometres. VEE TWO’s intensive race program over the last 20 years has enabled us to identify and rectify problems with Bevel Drive BigEnds.  The clearance between the crankpin, rollers and conrods is critical. 

Includes

Pin, Conrods, Needle Rollers and Cages, Thrust Washers

Ducati Part

0775.47.358

Blank main bearing sleeve semi finished can be machined to required tolerance

Advantages

Incorrectly sized Main Bearings Sleeves can be a trouble spot on Bevel drive Ducati's. If the fitment is a loose fit, the bearing sleeves can turn in their housings, or alternatively if the bearing sleeves are too tight, this can lead to cracked crankcases and an extremely short life span for your main bearings.

 

Material

Carbon Steel

 

Main bearing sleeve machined to standard size for all bevel twins. (86.05mm)

Advantages

Incorrectly sized Main Bearings Sleeves can be a trouble spot on Bevel drive Ducati's. If the fitment is a loose fit, the bearing sleeves can turn in their housings, or alternatively if the bearing sleeves are too tight, this can lead to cracked crankcases and an extremely short life span for your main bearings.

This standard sleeve is machined to the exact size as the factory intended on their drawings.

Material

Carbon Steel

Ducati Part

0755.49.205